Mohawk Lifts TP-20 - Two Post car lift and automotive lift

20,000 LB. HEAVY DUTY LIFT

Mohawk’s TP-20 lift uses double telescoping three stage swing arms and slider combination, has a clear floor design and adjustable height overhead hydraulic lines for ultimate flexibility (optional underground lines available).

THE 2 post lift for all of the vehicles in your shop.
Solid, SAFE & CERTIFIED

MOHAWK DESIGN & FEATURES

7”wide by 1” thick High strength fork lift channel construction

Lifts vehicles up to 20,000 lbs.
Surface mounted design bolts to the shop floor.
No in-ground oil tanks, no digging for installations, making installations fast and service easy.
Low profile, 3 stage arms for access under compact cars through medium duty trucks.
ALI safety certified to meet national and local OSHA & ANSI codes (ANSI/ALI ALCTV-2006) for the safety of your shop’s employees.
Light thru medium duty vehicles, Mohawk’s TP-20 lifts them all.
Constructed of heavy 7” x 1” fork lift mast channels (NOT formed sheet metal)
Each of the carriages ride on double sealed, self lubricating ball bearing rollers (NOT plastic slide blocks) for a lifetime of maintenance free service.
Direct drive lifting rods attached to each cylinder and carriage (no cables, chains, or pulleys) means no parts to wear or maintain
WIDE 48” base for stability.

BENEFITS

3 section swing arms make positioning easier than a 2 stage arm and increases lifting range, for all wheelbases.
5”, 7 1/2” and 10” stacking truck adaptors included to reach truck frames and get around fuel tanks or tool boxes.
Built Mohawk TOUGH—the TP-20 is the virtually the same structural column and same carriage used in Mohawk’s TP-26 and TP-30!
Built to last forever.

SAFETIES

Single position mechanical lock release, located at the main post, unlocks both safeties.
Release the mechanical locks with Mohawk’s air cylinders. Upon release, safeties immediately re-engage.
20,000 lb. capacity to safely raise fully loaded work and utility trucks.
14 position 11/2” thick steel plate safety locks in each post start engaging at 5” and continue through the full lifting height.
Optional safety gauge verifies lift has been lowered onto locks.